Month: May 2019

AS9100 7.1.5.2 Measurement Traceability

Airplane, aerospace, AS9100

Question

Can a manufacturer use “reference only” M&M equipment to accomplish in-process checks as long as these items are verified later on by “Inspection” using calibrated and/or verified equipment?

Would all of the measurements have to be verified by properly calibrated equipment?

Answer

The practice of using “reference-only” devices for in-process measures is not noncompliant with the standard.  The formal inspections to accept product would require use of calibrated equipment.

In clause 7.1.5.1, the standard clearly states “the organization shall determine and provide the resources needed to ensure valid and reliable results when monitoring or measuring is used to verify the conformity of products and services to requirements.”  And in clause 7.1.5.2, “hen measurement traceability is a requirement, or is considered by the organization to be an essential part of providing confidence in the validity of measurement results…”

Users and auditors should look at formal inspections steps and final buy-off to determine if any nonconformities were escapes from in-process measurements being conducted without calibrated devices.  Customer complaints can also be analyzed to see if any escapes were a result of failed in-process inspections.  If so, then the organization did not properly determine and provide the appropriate resources.

Buddy Cressionnie

For more information on this topic, please visit ASQ’s website.

Z1.4 Inspection Requirements

Automotive inspection, TS 16949, IATF 16949

Question

Our customers require that we follow the ANSI Z1.4 standard for attribute sampling plans; however, it is not feasible to wait until lots are completed to perform inspections. Lots can be large and run for many days and waiting until lot completion to determine the sample size, based on the finished lot size, is too late because we will have missed our chance to correct any production issues that may result in defective parts. Another limitation is a lack of space to stage product while waiting for the final inspection of the completed production lots. Product is made as orders are received, and not typically stored as inventory, so our on-time delivery demands also hinder our ability to hold product for final inspections of completed production lots. Therefore, we are seeking guidance on a practical way to implement a in-process inspection during production that follows the ANSI Z1.4 standard.

Answer

Yes, you can sample as you produce to get to the sample size.  It is important that you keep track of your accept/reject items.  Since you know how long you are running the product, you can project the approximate lot size to get the sample size.  Work with your scheduler before the product starts so you can take samples early and continue on in the process.

In addition, if you have material changes as the product is running, I am sure that you are sampling then to make sure everything is set correctly, you can use those samples also.  As an example, let’s say your product is running 4 days and based on the projected lot size, you have a sample of 28 to take, you could take 7 samples each day spaced throughout the day or you take 10 samples the first day, 7 the second day, 6 the third day and 5 the last day of production.  You need to figure the right sequence that fits your history of the product.

Jim Bossert

For more on this topic, please visit ASQ’s website.